Heavy Metal Affliction - 1989 Nissan 300ZX
Frankenstein might be the perfect comparison for Alex Millward’s 1989 Nissan 300ZX, except that Mary Shelley’s monster was far from attractive and Millward’s ride is absolutely gorgeous. What the two beasts do share is that they are built from a collection of parts put together to breathe new life into a body that to some might be considered dead. In Millward’s case it’s the classic form of the Z31 model Z-car.
There is also this quote from Shelley: “What can stop the determined heart and resolved will of man?” Millward has never given up on this car. Not after blowing up 14 engines over the 15 years he has owned the car. This is the second car he ever owned; a replacement to his first car, also a Z31, that he lusted after as a teenager when it was a family car in the garage.
The Millward family always had Z cars around. His aunt drove a 260Z, the family had a 280ZX and later upgraded to the 1986 300ZX. When Millward got his license, he bought the family car in a payment plan, then unfortunately proceeded to end its existence when he hit a patch of gravel and put it in a ditch. He was 16 then. He’s 30 now and he has learned from his mistakes.
Someone once said, “Failure is the key to success, each mistake teaches us something.” Millward knew he loved Z cars, so he hunted up and down the Pacific coast for the right one to replace the one he wrecked. He felt horrible parting out his first car to cover the towing bill but, he reasoned, at least the parts went to good homes. When he found this black 1989 Z31, he drove it much more carefully and it served as a daily driver through high school and college.
The car racked up a lot of miles driving to his job in college. His boss at that job had just done a turbo swap to his Porsche, and once Millward got to test drive the turboed 911, the boost bug bit him hard. At first he tracked down all the parts for a stock turbo swap and got that working. The car ran well on the 6.7psi of forced-induction, but it only lit the fuse in Millward.
“Feeling the itch for more power, I scratched it with a manual boost controller,” Millward said. Upping the boost to 12psi, a setting he had researched was “safe” gave the car a kick in the pistons. However, two weeks later the motor gave up dramatically. Fried pistons and destroyed rings. And so began a string of junkyard and JDM “low mileage” motors that fed Millward’s appetite for spool.
No, he didn’t blow them all up. Some were DOA, a couple motors shipped from Japan had piston-slap and were worthless from the get go. A couple fell to learning curve, such as the one where he forgot to tighten down the cam gear bolt. When that motor went about an hour after it was started it was catastrophic and memorable. “From each failure it allowed me to grow with the car,” Millward said, “and to eventually take me to where I am today with the car.”
Along the way, Millward has exposed nearly every weakness in the Z31 and remedied it with solutions that are either best practice or just plain out-of-the-box thinking. Here is where the Frankenstein analogy starts to kick in. The motor he chose to build came out of a Nissan Frontier. It’s the same block used in the Z31, but bored out to 3.3 liters. The transmission is out of a Z32 Twin-Turbo, and the rear end is from a 350Z.
Through hard driving, Millward learned the stock LSD with its two clutches would eventually act like an open differential due to heat buildup. The 350Z NISMO GT Pro LSD he installed has 20 clutches, and it has its own cooling system. The stock axles were never meant to handle this kind of horsepower so, they are much beefier now.
While the motor was being professionally built with forged internals to withstand the heat inflicted by 25psi of boost to make the over 600rwhp, Millward researched the best ways to improve the suspension and braking. After all what good is going fast, if you can’t reel it in just as quickly or quicker to keep it in between the ditches?
So the suspension got coil-overs, strut braces, sway bays, and polyurethane bushings. A little welding was involved to make those all work, but Frankenstein’s scars just made him look cooler right? For brakes, Millward found that he could have an adapter fabricated that would allow him to install the same 6-pot Brembo calipers used on front of the Cadillac CTS-V. These calipers are both effective and affordable. The rear 4-pot Brembo calipers fit an adapter made within the Z31 community and come from the Jeep SRT8. The result? “The braking of the car was phenomenal,” Millward said.
Millward is Nissan to the core. He built this extreme example the way he did to show just how much you can get out of the Z31. His daily driver is a Nissan Titan with a turbo diesel, and he bought his wife a Nissan Juke, also turbo-charged. He even has four very rare Z-car go-karts that he had to pay top dollar for.
Add to that Millward started his own online Z31 parts business, Z31Online.com, as a practical application of all he learned in building his car. He says he does it purely out of passion for the Z31 community but, it was partly to give all the Z31 lovers a place to find the parts they want rather than asking Millward where to find them.
Every component of this car has seen attention from the epic motor build you can see in the spec sheet (which, by the way, cannot even fit all the parts involved) to the interior dome light having an actual dimmer switch. “There isn’t much more that I could do,” Millward said, “I feel I have reached a completion point with the car.” So now he just wants to enjoy it. Somehow I actually believe this might be true, if it’s not the 14 engines over 15 years, it’s the finished product.
Back to the news